The CO₂ Release Kit comes ready assembled and all you will need to do is attach it to a suitable "vapour" release CO₂ bottle. It is important that you ensure the removable fibre washer (on regulator stem) is fitted to the nut joining the gas bottle for a complete seal. The Release Kit will come complete with all instructions and ample CO₂ tubing. Simply attach the tubing to the barbed fitting on the base of the regulator . Note that the barbed fitting is quite a lot smaller than the tubing. This is easily rectified by attaching a cable tie or ratchet clip around the tubing and fitting to give a tight fit.

Warranty

The CO₂ Release Kit is guaranteed against manufacturers defects and to withstand normal use for a period of one year. Damage caused by misuse, abuse or failure to follow instructions is not covered. Should you experience any problems please contact the point of purchase. A receipt must be produced to obtain any warranty repair work or a replacement.

Always use "Vapour" release carbon dioxide, liquid CO₂ will damage the release kit and void the warranty. Note that the flow meter is in litres per minute The flow meter should always be mounted vertically.

Warning

Danger: CO₂ is an asphyxiant in high concentrations.